855-635-4366

Valve Products
All Categories > Electric Actuated Valves > Item # DMC  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # DMC, Digital Modulating Controller




The DMC - Digital Valve Positioner is used in our flow control valves to proportionally position valve actuator between full open and closed positions via a 4-20mA or 0-10Vdc input signal. The card has been designed to be extremely easy to setup utilizing an on board microprocessor to store the zero and span positions with a simple button touch. It isn't necessary to cycle back and forth to set the zero and span. Local control switches on board allow for precise setting of the valve/actuator. Once you have the positions desired, simply store them in memory.

Optional Features
• Zero and Span Digital setup (no trim pots to adjust)
• 4-20mA or 0-10Vdc input - Jumper selectable
• Extremely compact design - 2.75" sq. x 1.4" wide
• Push button Local Control (Local/Remote Mode, Jog Hi, Jog Lo, Enter, Reset)
• Loss of Signal Command - Close, Stay Put, Open - Jumper selectable
• Reverse or Direct Acting - Jumper selectable
• Microchip 8 bit microprocessor with flash memory (retains software nearly indefinitely)
• 10 bit Analog to Digital converter chip
• Concurrent processor algorithm with interrupt routine
• On board transformer (AC version)
• 10 amp relay contacts for motor input
• UL508/CSA high voltage trace design
• 115 Vac or 12/24 Vdc power versions available (consult EVSCO for other power requirements)
• RS232 serial port header
• The DC version also has Speed control via pulse width modulation




Specifications  · Optional Features

Specifications

Input Current (250 ohm shunt)
Jumper Position - Lower two posts
4-20 mA

Input Voltage (DC)
Jumper Position - Upper two posts
0-10 V

Direct/Reverse Action
Jumpers set the action of the actuator. The unit is set at the factory for direct acting where the unit drives in a CW rotation upon receiving a low signal, i.e. 4mA = CW. The rotation is viewed from the top of the unit. However, moving the jumpers can set the unit to drive CCW upon receiving a low signal (reverse acting).


Optional Features

Dimensions
2.75 x 1.4 in.

Power Versions
115 Vac or 12/24 Vdc

Microchip
8 bit microprocessor with flash memory (retains software nearly indefinitely)

Transformer
On board transformer (AC version)

Jumper Selectable
4-20mA or 0-10Vdc input
Loss of Signal Command - Close, Stay Put, Open
Reverse or Direct Acting

Voltage Trace Design
UL508/CSA high voltage trace design

Serial Port Header
RS232 serial port header

Motor Input Options
10 amp relay contacts for motor input

Local Control
Push Button Local Control (Local/Remote Mode, Jog Hi, Jog Lo, Enter, Reset)


 MORE IMAGES 

·  Jumper Selections

·  Pushbutton Selections

·  Schematic Layout

·  Direct/Reverse Action


 DOWNLOADS 

Digital Modulating Controller Use and Care Manual
(PDF, 449KB)


EVSCO, Inc.
2309 N Ringwood Drive Suite M McHenry, IL 60050-1313
Toll Free: 855-635-4366 Tel: 847-362-7068   Fax: 847-362-7501   sales@evsco.com

Privacy PolicySitemapTerms & Conditions

© All rights reserved. EVSCO, Inc.